Epson MF1436-02 User Manual page 16

CHAPTER 4: GETTING STARTED
Notes on free run mode
(1) Any configuration information, various mask information and target program have not been written
in the flash memory built into the S5U1C63000H2 at the time of ex-factory. Even though the
S5U1C63000H2 enters in the free run mode without the data, it does not execute any target program
and while the program counter on the front panel indicates the reset address of 110H. Therefore, it is
necessary to write a target program, configuration information and various mask option information
into the flash memory in the ICE mode before setting the free run mode.
(2) In the free run mode, the break functions and the trace functions can not be used. The free run mode
only execute a target program and display the current program counter with the LEDs on the front
panel. The BRKIN terminal on the front panel becomes invalid.
(3) In the case any incorrect access exceeding configured program size or data RAM size is occurred by
reason of a improper target program, the S5U1C63000H2 immediately stops at the program counter,
where the incorrect access is made, by the LEDs on the front panel. In order to reset this situation, the
power should be off. Before the free run of the target program is carried out again, the program must
be completely debugged on the ICE mode. In the case any control to exceed program sizes such as
jump or call to outside of the program, it stops before the access to an incorrect area. In the case any
control to exceed data size such as read or write into outside of the data RAM area, it stops after the
access to the incorrect area.
(4) The S5U1C63000H2 may takes approx. 5 minuets after it is turned on until it starts execution of the
target program.
10
EPSON
(S1C63 FAMILY IN-CIRCUIT EMULATOR)
S5U1C63000H2 MANUAL