Advertisement
Available languages
Available languages
NOTE:
Fuel stabilizer
is an acceptable
alternative
in minimizing
the formation
of
fuel gum deposits
during
storage.
Add
stabilizer
to gasoline
in fuel tank or stor-
age container.
Always
follow the mix ratio
found
on stabilizer
container.
Run engine
at least 10 minutes
after adding
stabilizer
to allow the stabilizer
to reach
the car-
buretor.
Do not empty
the gas tank and
carburetor
if using fuel stabilizer.
ENGINE
OIL
Drain oil (with engine
warm)
and replace
with clean engine
oil. (See "ENGINE"
in
the Maintenance
section
of this manual).
CYLINDER
1.
Remove
spark plug.
2.
Pour one ounce
(29 ml) of oil through
spark plug hole into cylinder.
3.
Pull starter
handle
slowly
a few times to
distribute
oil.
4.
Replace
with new spark plug.
BATTERY
Disconnect
the battery
from the engine
connector
and charge
battery
48 hours.
OTHER
• Do not store gasoline
from one season
to another.
• Replace
your gasoline
can if your can
starts to rust.
Rust and/or
dirt in your
gasoline
will cause
problems.
•
If possible,
store your unit indoors
and
cover it to protect
it from dust and dirt.
• Cover your unit with a suitable
protec-
tive cover that does
not retain moisture.
Do not use plastic.
Plastic
cannot
breathe,
which allows
condensation
to
form and will cause your unit to rust.
IMPORTANT:
Never cover mower
while
engine
and exhaust
areas
are still warm.
_il, CAUTION:
Never store the lawn
mower with gasoline
in the tank inside a
building
where
fumes
may reach an open
flame
or spark.
Allow the engine
to cool
before
storing
in any enclosure.
TROUBLESHOOTING
- See appropriate
section
in manual
unless
directed
to a Husqvarna
Parts & Repair
Center.
PROBLEM
CAUSE
CORRECTION
1. Dirty air filter.
2. Out of fuel.
3. Stale fuel.
4. Water
in fuel.
5. Spark
plug wire disconnected.
6.
Bad spark plug.
7.
Loose
blade or broken
blade adapter.
8. Control
bar in released
position.
Does not start
1.
Clean/replace
air filter.
2.
Fill fuel tank.
3.
Empty
fuel tank and refill tank
with fresh,
clean gasoline.
4.
Empty
fuel tank and refill tank
with fresh,
clean gasoline.
5.
Connect
wire to plug.
6.
Replace
spark plug.
7.
Tighten
blade bolt or
replace
blade adapter.
8.
Depress
control
bar to
handle.
19
Advertisement
