Craftsman 113.236090 Owner's Manual page 14

'ii
Alignment (Adjustments) (continued)
Removing Pin End Blades
WARNING: To avoid injury from
accidental starting, always: turn
switch "OFF" and unplug power
cord from outlet before removing
or replacing the blade,
NOTE: Saw comes with pin end bfades.
if you are going to use piain end blades,
refer to the instructions under "Installing
Plain End Blades".
* Loosen tension on blade by turning ten-
sion knob counterclockwise
about three full turns
oLoosen upper and lower blade holder
knobs by turning the blade holder
knobs counterclockwise _ about
three full turns. To make lower blade
holder access easier, till the tabte to
45 °, and raise the arms to the up posF
tion using a screwdriver to rotate the
motor shaft.
o Remove blade from the lower blade
holder by pushing down or_ the upper
arm, releasing the pin end blade from
the lower blade holder. Remove blade
from the upper blade holder by slightly
lifting up on the blade and pulling for-
ward.
oseR
Tenslon Knob
Loosen
Upper
Holder
Lower Blade
Holder
14
.......