Craftsman 315.265030 Operator's Manual page 11

,_ WARNING:Donotconnect t o powersupply until
assembly i s complete. Failure to complycouldresult
inaccidental starting andpossible serious injury.
ASSEMBLING THE ROUTER TABLE
When you remove the parts and hardware from the pack-
ing materials, check all items with the packing list and
drawing. If you are unsure about the description of any
part, refer to the drawing. If any parts are missing, delay
assembling until you have obtained the missing part(s).
TO ATTACH THE LEGS
See Figure 3.
• Place router table top upside down on a flat, level
surface with the front edge closest to you.
• Place each leg in a corner of the table.
NOTE: The leg with the switch cut-out should be
placed in the front left corner of the table. The leg with
the warning label should be placed in the front right
corner of the table.
• Align the holes in the legs with the threaded holes in
the table.
• Use the hex key provided, secure each leg with the
socket head screws and lock washers.
SWITCH
ASSEMBLY
SWITCH
CUTOUT
Fig. 4
TO ATTACH THE UNDERTABLE GUARD
See Figure 5.
• Position the undertable guard around the throat of the
table.
• Align the three holes of the guard with the threaded
holes in the table.
• Use the hex key provided to secure the undertable
guard with the socket head screws and lock washers.
• Turn the router table upright and be sure the table is
stable and rests securely on all four legs.
LOCK SOCKET
WASHER HEAD
SCREWS
UNDER
TABLE
GUARD '_
Fig. 3
TO ATTACH THE SWITCH ASSEMBLY
See Figure 4.
• Hold the switch assembly so that the words ON and
OFF on the toggle switch are upside down.
• Place the switch assembly against the cutout in the left
front leg.
• Align the small holes in the mounting tabs with the
small holes in the leg.
• Using a phillips screwdriver, secure the switch
assembly to the leg with the small screws.
11
THROAT
I
i
&
Fig. 5