ProForm crosswalk sport User Manual page 7

2. 2
Remove theM10Nut(33),theM10x 50mmBolt
(27),andtheshipping bracket ( C)fromtheBase
(85).Attach a Wheel ( 86)withtheBoltandthe
Nutthatyoujustremoved. Donot overtighten
the Nut;the Wheelmustturn freely.Discard
theshipping bracket.
Press a BaseCap(82)intothe Base(85).
27
86
82
,
Identify the Right Upright (78) and the Right
Upright Spacer (80), which are marked with
"Right" stickers. Insert the Upright Wire (77)
through the Right Upright Spacer as shown. Set
the Right Upright Spacer on the Base (85).
Have a second person hold the Right Upright
(78) near the Base (85). See the inset drawing.
Tie the wire tie in the Right Upright securely
around the end of the Upright Wire (77). Then,
pull the other end of the wire tie until the Upright
Wire is routed completely through the Right
Upright.
77
78
Tie
Tie
78
80
,
Hold a Bolt Spacer (79) inside the lower end of
the Right Upright (78). Insert an M10 x 96mm
Bolt (5) with an M10 Star Washer (8) into the
Right Upright and the Bolt Spacer. Repeat this
step with a second Bolt Spacer (79), M10 x
96ram Bolt (5), and M10 Star Washer (8).
Hold the Right Upright (78) against the Right
Upright Spacer (80). Be careful not to pinch
the Upright Wire (77). Partially tighten the M10
x 96mm Bolts (5); do not fully tighten the
Bolts yet.
4
78
_8
, : 77
79
80