Gardena RP 240 Operating Instructions Manual page 6

Commissioning the pump if
it is installed out of water :
7
4
5
3
If the pump is installed out of water, the filter housing
be taken off.
1. Pull off the filter housing
2. Turn the pump inlet
the motor housing
3. Depending on the pumping application, the pump inlet can be
8
rotated in 90° steps. Twist the pump inlet
press it vertically on to motor housing
wise (see 5. Cleaning).
4. Screw stepped nipples
8
outlet .
5. Connect the pump inlet
(1/2 " or 3/4 " ) . The level in the water reservoir must be
6
higher than the pump inlet
6. Connect the pump outlet
(1/2 " or 3/4 " ) .
7. Fill the hose to the pump inlet
8. Insert the pump plug into a mains socket.
Caution : The pump will start immediately.
9. Use the flow control
spring.
4
.
5
anticlockwise and pull it vertically off
6
(bayonet socket).
6
7
on to the pump inlet
5
to the water reservoir with a hose
5
.
8
to the spring / gargoyle with a hose
5
with water.
3
to set the desired water flow for the
4
must
5
accordingly, again
and tighten it clock-
5
and pump
19