ProForm 650 User Manual page 7

7,
8,
Udentify the Right PedaU (63), which has an "R" moUdo
ed into its bottom surface, and the Right PedaUTube
(64), which is marked with a sticker,
Attach the Right PedaU(63) to the Right PedaUTube
(64) with two M8 x 1 9/16" Hex BoUts(41), two M8
Washers (52), and two M8 NyUon Locknuts (57),
Attach the Left PedaU(not shown) to the Left PedaU
Tube (not shown) in the same way,
AppUy a thin film of the included grease to the parts
shown at the right,
SHde a VVave Washer (50) onto the axUeon the Right
Crank Arm (15), Next, slide the Right PedaUTube (64)
onto the axUe,Attach the Right PedaUTube with an M8
x 3/4" Hex BoUt(26) and a NyUon Bushing (32),
Attach the Right PedaUTube (64) to the right
HandUebar Leg (5) with an M8 x 2 1/2" Hex BoUt(40),
an M6 Washer (55), and an M6 NyUonLocknut (56),
Repeat this step to attach the Left PedaUTube (not
shown) to the Ueftside of the elliptical exerciser,
Insert a Plastic Sleeve (16) into the top of the right
Handlebar Leg (5), Then, insert a Handlebar (6) into
the right Handlebar Leg, Align the holes in the
Handlebar with the holes in the Handlebar Leg,
Attach the Handlebar with two M6 x 5/8" Pocket
Screws (46), two M6 Arc Washers (39), and two M6
Nylon Locknuts (56),
Attach the other Handlebar (6) to the left Handlebar
Leg (5) in the same way,
41
64
52 57
J i
//
Grease
5
5O
Grease
64
26
Grease
56
G rease
9, Make sure that aH parts of the elliptical exerciser are properly tightened. Place a mat under the e[Hpflca[
exerciser to protect the floor or carpet from damage,
7