Craftsman SEARS 113.170370 Owner's Manual page 8

Positioning Detachable Blower
(Power Head Assembly)
1. Locate the detachable blower of your
Craftsman wet/dry vac.
2. On top of the blower (opposite the han-
dle side of the blower); there is molded
plastic lead that is used to assist
assembling the unit. Position the lead
into the indented area above the label.
Molded
Plastic Lead
Area
3. Rotate the detachable blower down
until the travel of the unit stops.
4. Lightly press down on the carry handle
of the detachable blower until the power
head latch engages the blower. The
detachable blower is now latched to the
lid assembly.
Power Head
Latch
Your new wet/dry vac is ready for use.
With the wet/dry vac completely assem-
bled and ready for use, insert the push but-
ton end of the hose assembly into the inlet
of the vae. The hose should snap into
place. To remove the hose from the vac
press the release button in the hose
assembly and pull the hose out of the vac
inlet.
\
Release
Button
Press and
Pull