Advertisement
_
Clamp
Clamp .I
_Fuel
Filter
CLEANING
• Clean engine, battery, seat, finish, etc.
of all foreign matter.
• Keep finished surfaces and wheels free
of all gasoline,
oil, etc.
• Protect painted surfaces with automo-
tive type wax.
We do not recommend using a garden
hose to clean your tractor unless the
electrical system, muffler, air filter and
carburetor are covered to keep water out.
Water in engine can result in a shortened
engine life.
CAUTION:
Before pedorming
any service or adjustments:
• Depress clutch/brake pedal fully and set parking brake.
• Place motion control lever in neutral (N) position.
• Place attachment
clutch in "DISENGAGED"
position.
• Turn ignition key "OFF" and remove key.
• Make sure the blades and all moving parts have completely stopped.
• Disconnect spark plug wire from spark plug and place wire where it cannot come
in contact with plug.
TRACTOR
TO REMOVE MOWER
• Place attachment
clutch in "DISEN-
GAGED" position.
• Turn height adjustment
knob to lowest
setting.
• Lower mower to its lowest position.
• Remove
retainer spring holding anti-
swaybar
to chassis bracket and
disengage
anti-swaybar from bracket.
• Remove
retainer springs from suspen-
sion arms at deck and disengage
arms
from deck.
• Raise attachment
lift to its highest
position.
Lift
Adjustment Nuts
Links
• Remove two retainer springs from each
front
link and remove links.
• Slide mower forward
and remove belt
from electric clutch pulley.
• Slide mower out from under right side
of tractor.
IMPORTANT:
If an attachment other than
the mower deck is to be mounted on the
tractor, remove the front links.
TO INSTALL MOWER
Follow procedure described in "INSTALL
MOWER AND DRIVE BELT" in the
Assembly
section of this manual.
Front Mower
Bracket
Front Suspension
Suspension Arms
Chassis
Bracket
Front Suspension
acket
Retainer
Spring
"_
Retainer Springs
Front Mower Bracket
Anti-Sway Bar
Retainer
Springs
23
Advertisement
