Advertisement
CLEAN AIR SCREEN
Air screen must be kept free of dirt and
chaff to prevent engine damage from
overheating. Clean with a wire brush or
compressed air to remove dirt and
stubborn dried gum fibers.
CLEAN AIR INTAKE/COOLING
AREAS
To insure proper cooling,
make sure the
grass screen, cooling fins, and other
external surfaces of the engine are kept
clean at all times.
Every 100 hours of operation (more often
under extremely dusty, dirty conditions),
remove the blower housing and other
cooling shrouds. Clean the cooling fins
and external surfaces as necessary. Make
sure the cooling shrouds are reinstalled.
NOTE:
Operating the engine with a
blocked
grass screen, dirty or plugged
cooling fins, and/or cooling shrouds
removed will cause engine damage due
to overheating.
ENGINE
OIL FILTER
Replace the engine oil filter every season
or every other oil change if the tractor is
used more than 100 hours in one year.
• Unscrew old filter by turning counter-
clockwise.
Use a suitable container to
catch oil.
• Apply a thin coating of new engine oil
to rubber gasket on replacement oil
filter.
• Install replacement oil filter by turning
clockwise until rubber gasket contacts
mounting surface, then tighten filter an
additional 1/2 to 3/4 turn.
• Fill crankcase with new oil (See "TO
CHANGE
ENGINE OIL" in this section
of this manual).
For approximate
capacity see "PRODUCT
SPECIFICA-
TIONS" section of this manual.
• Start engine and check for oil leaks.
Correct any leaks before placing
engine into full operation.
Oil Filter
AIR FILTER
Your engine will not run properly
using a
dirty air filter. Clean the foam pre-cleaner
after every 25 hours of operation or every
°
season.
Service paper cartridge every
100 hours of operation or every season,
whichever occurs first.
22
Service
air cleaner more often under
dusty conditions.
• Remove
knobs and cover.
TO SERVICE
PRE-CLEANER
• Wash it in liquid detergent
and water.
• Squeeze
it dry in a clean cloth.
• Saturate it in engine oil. Wrap it in
clean, absorbent
cloth and squeeze to
remove
excess oil.
• If very dirty or damaged,
replace pre-
cleaner.
TO SERVICE CARTRIDGE
• Clean cartridge
by tapping gently on
flat surface.
If very dirty or damaged,
replace cartridge.
• Reinstall
precleaner
cartridge,
cover
and secure with knobs.
IMPORTANT:
Petroleum solvents, such
as kerosene,
are not to be used to clean
the cartridge.
They may cause deteriora-
tion of the cartridge.
Do not oil cartridge.
Do not use pressurized
air to clean or dry
cartridge.
Knobs
_
Cover
ge
Foam
Pre-cleaner @
MUFFLER
Inspect and replace corroded muffler and
spark arrester (if equipped) as it could
create a fire hazard and/or damage.
SPARK PLUGS
Replace spark plugs at the beginning of
each mowing season or after every 100
hours of operation, whichever occurs first.
Spark plug type and gap setting are
shown in "PRODUCT
SPECIFICATIONS"
section of this manual.
IN-LINE FUEL FILTER
The fuel filter should be replaced once
each season. If fuel filter becomes
clogged, obstructing fuel flow to carbure-
tor, replacement is required.
• With engine cool, remove filter and
plug fuel line sections.
• Place new fuel filter in position in fuel
line with arrow pointing towards carbu-
retor.
Be sure there are no fuel line leaks and
clamps are properly positioned.
Immediately wipe up any spilled gaso-
line.
Advertisement
