Specifications; Glossary; Duty Cycle - Craftsman 921.166370 Owner's Manual

Important Safety Instructions& Guidelines
Risk of Breathing Avoid using the air compressor in confined areas. Always have adequate space
(12 inches) on all sides of the air compressor° Also keep children, pets, and others out of
i_._,o the area of operation..This air compressor does not provide breathable air for anyone or
_2_:
any auxiliary breathing device Spraying material will always need to be in another area
from the air to not allow intake air to damage the air filter..
away
compressor
compressor
Risk of
Never utilize the air compressor in the rain or wet conditions. Any electrical issues or
Electrical Shock
repairs should be performed by authorized personnel such as an electrician and should
comply with all national and local electrical codes. The air compressor should also have
"__ the proper three prong grounding plug, correct voltage, and adequate fuse protection.
I
I
.......... ., ..-, .... .......................................
Risk of Never operate the compressor near combustible materials, gasoline or solvent vapors. If
Explosion or Fire spraying flammable materials, locate the air compressor at least 20 feet away from the
spray area. Never operate the air compressor indoors or in a confined area
Risk of Bursting
! '
k
Always drain the air compressor tank daily or after each use. If the tank develops a leak,
then replace the air compressor. Never use the air compressor after a leak has been
found or try to make any modifications to the tank. Never modify the air compressor's
factory settings which control the tank pressure or any other function..
Specifications
Pump ................................ Oil-lube direct drive
Motor .................................... lt0 HP (Induction)
Bore ......................................................... 1..65"
Stroke ................................................. 1..26"
Voltage Single Phase ........................... 120 VAC
Minimum Circuit Requirement .................. 15 Amps
Air Tank Capacity ................................. 4 Gallons
Cut-in Pressure ...................................... 95 PSI
Cut-out Pressure .................................. 125 PSI
SCFM @ 90 PSI ........................................... 2.4
Oil Capacity ............................... 90 mL or 3 oz_
Oil Type .............................. SAE 30 Non-detergent
Glossary
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per minute; a unit of measure
for air delivery
PSIG: Pounds per square inch gauge; a unit of measure
for pressure.,
ASME: American Society of Mechanical Engineers.
California Code: Unit may comply with California Code
462 (I) (2)/(M) (2).,
Cut-In Pressure: The air compressor will automatically
start to refill the tank when the pressure drops
below the prescribed minimum.
Cut-Out Pressure: The point at which the motor stops
when the tank has reached maximum air
pressure°
Code Certification: Products that bear one or more of
the following marks: UL, ULc, ETL, CSA, have
been evaluated by OSHA-certified independent
safety laboratories and meet the applicable
Underwriters Laboratories Standards for Safety
Duty Cycle
This is a 50% duty cycle air compressor,
could damage the air compressor_
Do not run the air compressor more than 30 minutes of one hour.. Doing so