Safety Precautions; Cleaning The Lint Filter - Haier XPB60-0713S User Manual

× ¢ Ò â Ê Â Ï î

Safety precautions

Please insert the power cord into special
receptacle with rated voltage.Be sure to
use single-phase two pins receptacle.If
possible,please adopt electric leakage
protector.
Earth
Do not bend, stretch, twist, bind the power cord by force,
or reform it. Do not press or clamp it with heavy items.
Keep the prong of the power plug clean.
If dust is found on the power plug, please wipe it off with dry cloth.
If the power cord and power plug are bad, or the receptacle is loose,
be sure to have it replaced by the technicians of our special shop
or our agent, or the after-sale service department for the sake
of avoiding any risk.
Do not put the machine at damp
place like the bathroom . Never
wash it with water. Do not place
wet laundries on the control panel.
For washing machine with ventilation
openings in the base, that a carpet
must not obstruct the openings.
Ventilation hole at
the bottom of the
washing machine
Do not let the machine share one receptacle
with other electric appliances. If the power
plug is damaged, or the plugging into the
receptacle is loose, do not use the plug any
more.
When the machine is normally using, please put the
power plug at the location easily to be inserted and
extracted by hand. Be sureto pull the plug off when
there'spower failure, or the machine is being moved,
cleaned orwhen it is idle.
Do not use water hotter than 50 C .
Do not wash water-proof laundries like
the raincoat, bike covers etc. to avoid
abnormal vibrations.
2
Maintenance
Ï ´ º ó ´ ¦ À í
After using, please clean the lint and eyewinker of the lint filter and
overflow filter in time. Otherwise it may influence your using the machine.
Please first pull off the power plug from the receptacle before cleaning.

Cleaning the lint filter

The lint filter must be used during washing.
It must be cleaned in time after each using.
1. Take off the lint filter
Put hand at the indicated position.
Push down to take it off. ( See
Figure 1)
2. Clean the lint
Put it in water and clean while it is
still wet.(See Figure 2)
3. Install the lint filter
After cleaning, insert the bottom
of the lint filter ( marked with
"down side") into the overflow filter ,
then push the upper part of the
filter in ( marked with " up side ").
(See Figure 3)
Cleaning the overflow filter
Too much lint on the overflow filter will influence
the normal usage of the machine. Please
clean it every two months.
Take off the overflow filter.
As indicated in the figure, nip the elastic fixing
claw and pull it to the direction of the arrow to
take it off.
Figure 1
Figure 2
Figure 3
Elastic fixing
claw
11