Advertisement
_k
WARNING:
When servicing use only identical
Craftsman replacement parts. Use of any other
parts may create a hazard or cause product damage.
GENERAL
All parts represent an important part of the double
insulation system and should be serviced only by a
qualified Sears service technician.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, carbon dust, etc.
,_
WARNING:
Do not at any time let brake fluids,
gasoline, petroleum-based
products, penetrating oils,
etc. come in contact with plastic parts. They contain
chemicals that can damage, weaken, or destroy
plastic.
It has been found that electric tools are subject to
accelerated wear and possible premature failure when
they are used on fiberglass boats, sports cars, wallboard,
spackling compounds, or plaster. The chips and grindings
from these materials are highly abrasive to electric tool
parts such as bearings, brushes, commutators,
etc.
Consequently,
it is not recommended that this tool be
used for extended work on any fiberglass material,
wallboard, spackling compounds, or plaster. During any
use on these materials it is extremely important that the
tool is cleaned frequently by blowing with an air jet.
EXTENSION
CORDS
The use of any extension cord will cause some loss of
power. To keep the loss to a minimum and to prevent tool
from overheating, use an extension cord that is heavy
enough to carry the current the tool will draw.
A wire gage size (A.W.G.) of at least 16 is recommended
for an extension cord 100 feet or less in length. When
working outdoors, use an extension cord that is suitable
for outdoor use. The cord's jacket will be marked WA.
,_
CAUTION:
Keep extension cords away from the
sanding area and position the cord so that it will not
get caught on lumber, tools, etc., during sanding.
,_
WARNING:
Check extension cords before each
use. If damaged replace immediately. Never use tool
with a damaged cord since touching the damaged
area could cause electrical shock resulting in serious
injury.
Extension cords suitable for use with your sander are
available at your nearest Sears Retail Store.
,_
WARNING:
Always wear safety goggles or safety
glasses with side shields during power tool operation
or when blowing dust. If operation is dusty, also wear
a dust mask.
LUBRICATION
All of the bearings in this tool are lubricated with a
sufficient amount of high grade lubricant for the life of the
unit under normal operating conditions. Therefore, no
further lubrication is required.
The following recommended
accessories are currently available at Sears Retail Stores.
NON LOADING ALUMINUM OXIDE
ADHESIVE BACKED (3-2/3 in. x 7-1/8 in.)
Extra Fine
Fine
Medium
Coarse
ALUMINUM OXIDE SHEETS
(3-2/3 in. x 9 in.)
Fine
Medium
Coarse
_IL WARNING:
The use of attachments or accessories not listed might be hazardous.
,_
WARNING:
The operation of any sander can result in foreign objects being thrown into your eyes, which can
result in severe eye damage. Before beginning power tool operation, always wear safety goggles or
safety glasses with side shields and a full face shield when needed. We recommend Wide Vision
Safety Mask for use over eyeglasses or star_dard safety glasses with side shields, available at Sears
Retail Stores.
11
Advertisement
