Advertisement
Available languages
Available languages
_"].__I i_ I _] _'il
Contents
of Carton
1 - Air Compressor
1-
Handle
4 - Self Tapping Screws
2-
Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
1 - Rubber Strip
Tools Required
for Assembly
1 - 9!16" socket or open end
wrench
1 - 3/8" socket or open end wrench
Unpacking
1.
Remove unit from carton and
discard all packaging. NOTE:
Save all parts bags.
Assemble
Handle
1.
2.
3.
Insert the handle inside the
compressor saddle and line up
the two bolt holes on each side.
Install the four screws, two on
each side.
Tighten securely.
Assemble
Wheels
It will be necessary
to brace or support
one side of the outfit when
installing the wheels because the
compressor will have a tendency to
tip.
1.
Attach wheels with shoulder
bolts and nuts as shown.
NOTE: Place the bolts in the
bottom hole of the wheel bracket
on units 20-29 gallons and in the
top hole on units 30 gallons and
up.
2.
Tighten securely. NOTE: The
outfit will sit level if the wheels
are properly installed.
The wheels and
handle do not
provide adequate
clearance,
stability or support for pulling the
unit up and down stairs or steps.
The unit must be lifted, or pushed
up a ramp.
Assemble
Rubber
Strip
1.
Clean and dry underside of air
tank leg opposite wheels.
2.
Remove the protective paper
strip from the adhesive backed
rubber foot strip.
3.
Attach the rubber foot strip to
the bottom of leg. Press firmly
into place.
/
_1
t
Shoulder Bolt
Rubber
Strip
D27603
10-ENG
Advertisement
