Table of Contents
Advertisement
Message
fjgi_board_init_mem:
Failed to dma_alloc !!
statistick block can't
alloced!!
hwmib block can't alloced
handle!
hwmib block can't bind
handle!
fjgi_board_init_mem:
Failed to dma alloc2!!
Illegal value for
LinkSpeed_A
fjgi_hw_init:Step 22
failed !!
fjgi_hw_init:Step 23
failed !!
fjgi_hw_init:Step 43
failed !!
Illegal combination of
values AutoNeg and Speed
Except for the above
*1: This appears only when 1000Mbps is used.
Table 4.4 Machine management report messages
Message
fjgi_device_check:
fjgi_hw_deinit failed !
fjgi_device_check:
fjgi_hw_init failed !
pci_config_setup_failed
4.5
Using GigabitEthernet on a Cluster System
4.5.1 Support for Cluster System
The contents of support at the time of using by the cluster system, the environmental setting method, etc. are
explained.
GigabitEthernet has the following functions on the cluster system:
28
DMA resources cannot be allocated.
Statistic
information
couldn't be allocated.
DMA resources cannot be allocated.
The value of LinkSpeed_A of a
setting file was wrong.
The error occurred in initialization.
Auto speed couldn't be set in fixed
mode.
There is the possibility that is Driver
internal bug or Hardware failer.
The error occurred in initialization of
an adapter.
Acquisition of PCI configuration
space went wrong.
Operation standby mode
Cause
resources
Meaning
Workaround
Please set a right value of
LinkSpeed_A.
Hardware failure was occurred. Please
report to your authorized dealer.
Please set value except Auto in
LinkSpeed_A.
Report that to your authorized dealer.
Workaround
There is the possibility of hard
abnormalities. Report them to your
authorized dealer.
There is the possibility of the shortage
of resources or hard abnormalities.
Please check the empty space of a
memory. Report them to your
authorized dealer.
Advertisement
Table of Contents
