Rear Panel Gigrac 300 - SoundCraft GIGRAC User Manual

Rear Panel GigRac 300

Rear Panel GigRac 300
Rear Panel GigRac 300
Rear Panel GigRac 300 Rear Panel GigRac 300
(1) Power Switch
This switch turns the GigRac On or Off. The red Power LED (13) on the
front panel will illuminate to confirm this.
NB! Before switching the GigRac On or Off, make sure
that the Main and Mon Master Volume controls are
(2) Power Socket
Connect the supplied power cable to this socket.
(3) Speakers Outputs
The Speaker Outputs are available as Neutrik Speakon connectors and
standard ¼" Jack connectors.
Connect your loudspeakers to these outputs. The signal sent to the
Speakon connectors and the Jack sockets is exactly the same.
Use the appropriate connector type to match the input connectors on
your loudspeakers.
The minimum load that the amplifier inside the GigRac should be presented
with is 4 ohms. This means that a single 8 ohm speaker can be connected
to each of the speaker outputs as shown in Fig1, or two 8 ohm speakers
can be connected in parallel to one of the speaker outputs as shown in
Fig 2. Two speakers connected like this gives a combined load of 4
ohms.
30
turned fully down.