Rear Panel Gigrac 600 - SoundCraft GIGRAC User Manual

Rear Panel GigRac 600

Rear Panel GigRac 600
Rear Panel GigRac 600
Rear Panel GigRac 600 Rear Panel GigRac 600
(1) Power Switch
This switch turns the GigRac On or Off. The red Power LED (13) on the
front panel will illuminate to confirm this.
NB! Before switching the GigRac On or Off, make sure
that the Main and Mon Master Volume controls are
(2) Power Socket
Connect the supplied power cable to this socket.
(3) Speakers Outputs (Amp 1 and Amp 2)
The Speaker Outputs are available as Neutrik Speakon connectors and
standard ¼" Jack connectors.
Connect your loudspeakers to these outputs. The signal sent to the
Speakon connectors and the Jack sockets is exactly the same.
Use the appropriate connector type to match the input connectors on
your loudspeakers. The GigRac 600 is designed to work with loudspeakers
rated at either 8 ohms or 4 ohms.
The minimum load that either of the amplifiers inside the GigRac 600
should be presented with is 4 ohms. this means that a single 4 or 8 ohm
speaker can be connected to each amplifier outputs as shown in Fig 1.
Alternatively, two 8 ohm speakers can be connected in parallel to each
amplifier output, as shown in Fig 2. Two speakers connected like this
gives a combined load of 4 ohms.
28
turned fully down.