Page 14
Z276a M2x6mm 73406 73406 Z276a Z276a 73401 Align tab and slot Z275d before tightening Z275d M2x5 screw. Richten Sie vor dem anziehen der Schraube den Schlitz und die Lasche aus. Aligner la patte et la fente avant de serrer les vis Use your finger to hold shaft in place.
Page 29
CH. 2 Battery AM Receiver crystal (RX) Motor Yellow For more info, refer to Page 2. Receiver Switch Be sure to pull on the connector. 306 HPI MICRO PRO CONTROL Pulling the wire can cause damage. Page 1/4 I-12631-1 I-308-1...
Page 30
To be used for trimming the throttle operation. Steering Wheel Throttle trigger Straight (Neutral) Left turn Right turn HPI TF-3 (AM) Transmitter Reverse / Brake Forward Stop (Neutral) To be used for steering operation. To be used for throttle operation.
Rear Spool Gear Installation If you are an advanced drift driver, and want a more aggttessive setup, you can install the Rear Solid Diff Pully. More detailed instructions are on page 6 of your kit maunal. Differential Gear Removal Spool Gear Installation Adust motor screws sogears mesh smoothly.
ALUMINUM FRONT DIFF FRAME (MICRO RS4) 73435 MICRO SERVO SAVER SET (MICRO RS4) 4152 HPI MICRO PRO FOAM TIRE 14mm (A/MEDIUM) WITH DISH WHEEL WHITE 72450 BALL DIFFERENTIAL SET (MICRO RS4) 73436 STEERING LINK AND SERVO MOUNT SET (MICRO RS4)
Need help?
Do you have a question about the micro RS4 and is the answer not in the manual?
Questions and answers