Table of Contents
Advertisement
INSTALLING GLASS DOORS
Spring clips have been installed. Some adjust-
ments may be needed. Install doors using the
following steps:
1. With bifold doors completely folded, insert
bottom pivot pin into pivot hole located
near bottom corner of front face opening
and swing door to vertical position making
sure top pins slide into door track. Door
is installed when top door pin snaps into
spring clip.
2. Repeat step 1 for remaining door.
If you find the doors do not close properly or
do not appear level or straight, proceed with
section on door adjustment,
Fold Door
and Slide
Top Pins
Into Track
Figure 29 - Installing Bi-Fold Doors
30
glaSS dOOr inStallatiOn
Spring
Clip
Insert Pin
into Spring
Clip
Insert
Bottom
Pivot Pin
into Hole
Pivot
Hole
www.fmiproducts.com
Continued
DOOR ADjUSTMENT
Remove doors and slightly loosen lower pivot
clips and upper spring clips. Replace doors
and fully close them. Use 1/8" shims (any
material) to level doors. Once proper setting
is achieved, carefully open doors enough so
that you can access spring clips with a phillips
screwdriver. Tighten screws. See Figure 30.
Figure 30 - Adjusting Bi-Fold Doors
122273-01D
Advertisement
Table of Contents
