Table of Contents
Advertisement
Chapter 2: Hardware Installation & Setup
This chapter provides information about your NetComm ADSL Modem Router's physical
features and gives step-by-step installation instructions.
2-1 Rear Panel & Connections
The following figure shows the rear view of the NetComm ADSL Modem Router and illustrates
how the cables connect to the interfaces on the rear panel.
Plug one end of the UTP cable into the WAN port, the other into the the other into the wall
jack that is connected to the ADSL service.
Connect a computer, with a Network Interface Card installed, to one of the four LAN Ports.
Connect the external power supply to the NetComm ADSL Modem Router.
Port 4 can cascade to another network device (usually a hub or switch). Make sure the slide
switch is in "X" mode when connecting to an MDI-X port.
The Reset button is used to reboot the device - press once quickly, or for clearing
configuration settings back to factory default values - press for longer than 3 seconds.
www.netcomm.com.au
Page 10
Rev.1 - YML632
ADSL Modem Router
Advertisement
Table of Contents
