Yamaha YPG635MM Owner's Manual page 11

2
w
6 x 70 mm
roundhead screws
3
e
6 x 30 mm roundhead screw
4
r
Support rail
t
4 x 45 mm
flathead
screws
x
shown. The joint connectors have been installed properly if
you can see the screw head on the connector.
q
Joint connectors
using the screws w. The left and right stand bases are the
same shape, and there is no difference between their front-
to-back orientation. If you have trouble fastening the
screws, use a screwdriver to rotate the joint connectors so
that the connector holes are aligned with the screw holes
on the stand bases.
c
back-to-front orientation for the side boards. Make sure the
non-colored surface is facing down.
v
ment on the sheet with the rear panel side on the bottom.
of the instrument and attach the rail, using the screws t.
Attach the stand bases.
Insert the joint connectors q into the stand boards as
NOTE
• If you put the connectors in wrong direction and want to take them out,
tap around the holes on the boards.
Attach the stand bases to the bottom of the side boards,
Attach the back board.
Attach the back board, using the screws e. Check the
CAUTION
• Be careful not to drop the back board or touch the sharp metal fit-
tings.
NOTE
• If you have purchased an optional pedal unit, attach the pedal unit
before proceeding to the next step. Refer to the instructions provided
with your pedal unit.
Attach the support rail.
Spread the packing sheet on the floor. Place the instru-
Align the support rail r into the groove on the bottom
NOTE
• If you don't have the packing sheet, use a thick blanket or other soft
material to protect the floor and the instrument.
DGX-630/YPG-635 Owner's Manual
Setting Up
11