Enterasys RoamAbout RBT-8200 Installation Manual page 25

2. Press Enter three times, to display a username prompt (Username:), a password prompt
(Password:), and then a command prompt such as the following:
RBT-8200-aabbcc>
(Each switch has a unique system name that contains the model number and the last half of
the switch's MAC address.)
3. Access the enabled level (the configuration level) of the CLI:
RBT-8200-aabbcc> enable
4. Press Enter at the Enter password prompt.
5. Type quickstart. The command asks you a series of questions. You can type ? for more help.
To quit, press Ctrl+C. The following example code accepts the defaults for system name and
country code, and does not configure SSIDs, user information, or distributed access points.
Username: admin
Password:
RBT-8200-111400> enable
Enter password:
RBT-8200-111400# quickstart
This will erase any existing config. Continue? [n]: y
Answer the following questions. Enter '?' for help. ^C to break out
System Name [RBT-8200]:
Country Code [US]:
System IP address []: 182.29.1.250
System IP address netmask []: 255.255.255.0
Default route []: 182.29.1.1
Admin username [admin]:
Admin password []: admin
Do you wish to set the time? [y]: y
Enter the date (dd/mm/yy) []: 22/05/05
Enter the time (hh:mm:ss) []: 10:03:01
Enter the timezone []: EST
Enter the offset from GMT for 'EST' in hh:mm [0:0]: -5:00
Do you wish to configure wireless? [y]: n
success: created keypair for ssh
success: created keypair for admin
success: created self-signed certificate for admin
success: remember to save this config
RBT-8200#
6. Optionally, enable Telnet.
RBT-8200# set ip telnet server enable
7. Verify the configuration changes.
RBT-8200# show config
8. Save the configuration changes.
RBT-8200# save config
Wireless Switch Configuration Tasks
RBT-8200 Wireless Switch Installation Guide 2-3