Craftsman 138.75275 Operator's Manual page 17

/ i _{oll]_]l_,.']][[oIo_
PROBLEM
Motor buzzes but fails
to run.
No Water
POSSIBLE CAUSE
Supply voltage below mini-
mum.
SOLUTION
Verify that only the pressure
washer is running on this circuit.
System has residual pres- Turn unit "OFF", squeeze trigger
sure. on spray wand to release pres-
sure, then turn unit "ON".
Voltage loss due to Unplug any extension cords at-
extension cord. tached and plug the unit directly
into the outlet.
Pressure washer not used for Call the Toll-Free Customer Help
long periods. Line.
Residual friction among com- Disconnect water supply and
ponents. Unit might hum. power ON for 2 to 3 seconds,
repeat couple times or until the
motor starts.
Tripped circuit breaker
Quick connect assembly is
attached in reverse.
Switch off pressure washer,
squeeze trigger gun waiting for a
steady flow of water emerge from
spray nozzle, then turn on the unit.
( ensure when you turn on the unit
, trigger gun is at "on" position).
Verify that Inlet adapter is attached
to machine's water inlet and
that the quick connect coupler is
attached to garden hose.
Water supply is OFF. Turn ON water supply.
Kink in the garden hose. Remove kink in garden hose.
17-English