Advertisement
E
There is a cord lock feature on the handle
to prevent the extension cord from
detaching during use. Plug the cord into
the unit, then secure the cord as shown.
(A 16-gauge round, 3-wire outdoor
extension cord is recommended.)
F
ALWAYS START AND STOP THE
POLISHER
ON OR AGAINST
THE CAR
SURFACE.
Place the extension cord over your shoulder
and do flat surfaces first---hood,
trunk and
roof. Cover areas quickly with broad,
sweeping strokes in a criss-cross
pattern.
DO NOT press down on the polisher.
The machine's
action,
not pressure,
does the best job.
H
Remove the wax applicator bonnet and
use it to hand-polish all hard-to-reach
surfaces; under the bumpers, around the
door handles, etc.
Throw away the wax applicator bonnet
and put a clean terrycloth bonnet on the
polisher. Set the function selector switch to
POLISH/BUFF.
J
Polish the wax in the same order it was
applied. Use long, sweeping strokes in a
criss-cross pattern, Do not press hard. Let
the polisher do the work.
G
After flat surfaces
are covered with wax,
do sides of the car. Hold the polisher
as
shown. Let the cord hang free. It is not
necessary
to use a criss-cross
motion on
doors and fenders.
K (OPTIONAL)
To produce the deepest shine use a lambs
wool bonnet (available as an accessory) for
buffing. Set the function selector switch to
POLISH/BUFF and go back over entire car.
4
Advertisement
