Vac Assembly - Craftsman 113.179100 Owner's Manual

Assembly (continued)
8,
9,
Insert the caster stem into the socket
of the caster foot as shown. (Front
casters only).
Push on the caster until the ball on
the caster stem is inserted all the way
into the socket. You will be able to
hear the ball snap into the socket and
the caster will swivel easily when
positioning is correct.
10. Install (4) #10 x 1-3/4" screws into
matching holes on both right and left
side of caddy, securing the caddies to
the bottom of the drum. Tighten
screws until just snug. Do not over
tighten the screws, as this may
deform the caddies.
C _, _ Caster Stem
aster (zj _ _ Caster Ball
Socket I
--#10 x 1-3/4"
Screw (4)
Vac Assembly
1. Position the powerhead assembly on
the drum/caddy assembly as shown
(assembled earlier).
2. Rotate both latches down and press
until you hear them snap over the
flanges on the drum.
Drum
Latch
Drum
Latch