Advertisement
Available languages
Available languages
_k
WARNING:
Always wear safety gogglQsor
safety glasses with side shields when operating
tools. Failure to do so could result in objects
being thrown into your eyes, resulting in possible
serious injury.
WARNING:
Do not allow familiarity with your
trim saw to make you careless. Remember that a
careless fraction of a second is sufficientto inflict
severe injury.
CHARGING
YOUR TRIM SAW
The battery pack for this tool has been shipped in a
low charge condition to prevent possible problems.
Therefore, you should charge it until light on front of
charger changes from red to green.
Note: Batteries will not reach full charge the first time
they are charged. Allow several cycles (cuffing
followed by recharging) for them to become fully
charged.
TO CHARGE
•
Charge battery pack only with the charger
provided.
•
Make sure power supply is normal house
voltage, 120 volts, 60 Hz, AC only.
•
Connect charger to power supply.
•
Place battery pack in charger aligning raised rib in
charger with groove in battery pack.
•
Press down on battery pack to be sure contacts on
battery pack engage properly with charger
contacts.
•
Red light shouldturn on. Red light indicates fast
charging mode.
If red light is flashing, this indicates battery pack is
deeply dischargedor hot.
If battery pack is hot, red light should become
steady after battery pack has cooled down.
If battery pack is deeply discharged, red light
should become steady after voltage has increased,
normally within 30 minutes.
if after one hour red light is stillflashing, this
indicates a defective battery pack and should be
replaced.
Green lighton indicates battery pack is in slow
charging mode or fully charged.
Yellow light on and red light flashing indicates
defective battery pack. Return battery pack to your
nearest Sears Repair Center for checking or
replacing.
•
When your battery pack becomes fully charged, the
red light will turn OFF and the green light willturn
ON.
•
If you remove batte_ pack from charger and
reinsert it immediately (less than 5 seconds)
back in charger, the green light will come on
indicating full charge and slow charging mode
until removed from charger. If you remove
battery pack from charger and wait more than 5
seconds before reinserUng it back in charger,
the charger will function normally.
• After normal usage, 1 hour of charging time is
required to be fully charged. A minimum charge
time of 1-1/2 hours is required to recharge a
completely discharged tool.
•
The battery pack will become slightlywarm to the
touch while charging. This is normal and does not
indicate a problem.
•
DO NOT place charger in an area of extreme heat
or cold. It will work best at normal room
temperature.
_k
CAUTION:
Your battery pack contains special
high temperature batteries to help prevent battery
damage when left on charge for extended periods
of time. However, once the batteries become fully
charged, w_ recommend that you unplug your
charger from power supply.
_1 im
LED FUNCTION OF CHARGER
LED WILL BE LIGHTED TO INDICATE STATUS OF CHARGER AND BA'I'rERY PACK:
•
Red LED Lighted = Fast Charging Mode.
•
Green LED Lighted = Slow Charging Mode and Fully Charged Battery Pack.
•
Red LED Flashing = Hot or Deeply Discharged Battery Pack. Also Defective
Battery Pack After 1 Hour.
•
Yellow LED Lighted and Red LED Flashing = Defective Battery Pack.
9
Advertisement
