Advertisement
Clean and Replace Spark Plug
Change the spark plug every 100 hours
of operation or once each year,
whichever comes first. This will help
your engine to start easier and run
better.
.030" (0.76 MM)
Resistor
PUMP
This screen filter should be checked
periodically
and cleaned if necessary.
1.
Remove filter by grasping end and
removing it from water inlet of
pump as shown.
2.
Clean filter by flushing it with water
on both sides.
3.
Re-insert filter into water inlet of
pump. NOTE: Cone side faces
out.
NOTE: Do not operate pressure
washer without filter properly installed.
WAND
If the nozzle becomes clogged with
foreign materials, such as dirt,
excessive pressure may develop.
If the
nozzle becomes partially clogged or
restricted, the pump pressure will
pulsate.
Clean the nozzle immediately
using the nozzle kit supplied and the
following instructions:
1.
Shut off the pressure washer and
turn off the water supply.
2.
Disconnect
spark plug wire.
3.
Pull trigger on gun handle to
relieve any water pressure.
4.
Disconnect
the wand from the
gun.
5.
Remove the nozzle from the end
of the wand with the
2mm allen
wrench provided as shown.
6.
Clean the nozzle using the nozzle
cleaner provided or a straightened
paper clip. Insert into the nozzle
end and work back and forth until
obstruction
is removed.
7.
8.
9.
10.
11.
Direct water supply into nozzle
end to backflush loosened
particles for 30 seconds.
Reconnect spark plug wire.
Reassemble the nozzle to the
wand. Tighten securely to prevent
leaks.
Reconnect wand to gun and turn
on water supply.
Start pressure washer and place
wand into high pressure setting to
test.
D28234
16- ENG
Advertisement
