Name Of Each Part; Indoor Unit; Remote Controller; Installing The Remote Controller Batteries - Mitsubishi Electric MR. SLIM MCF-D18VD Operating Instructions Manual

• OPERATING INSTRUCTIONS •
N
AME OF EACH PART

Indoor unit

Horizontal vane
Vertical vane
When installed on the ceiling
Outdoor unit
Appearance of the outdoor unit may differ from some models.
P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.

Installing the remote controller batteries

4.
Press RESET
1.
Remove the front lid
3.
Install the front lid
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries. The remote controller could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
• Press RESET gently using a thin stick.
If the RESET button is not pressed, the remote controller may not operate correctly.
En-3
Display section
Operation indicator
lamp
Remote control
receiving section
Front panel
Air inlet
Air cleaning fi lter (Option)
Air fi lter
Deodorizing fi lter (Option)
Emergency operation switch
Page 4
Air inlet (back and side)
Piping
Drainage hose
Air outlet
Drain outlet
2.
Insert AAA
alkaline batteries

Remote controller

Operation display
section
ON/OFF
(operate/stop)
button
FAN speed
control button
Page 5
Operation
select button
Page 4
VANE
control button
Page 5
Use the remote controller provided with the unit only.
Do not use other remote controllers.

Setting current time

1.
Press CLOCK
3.
Press CLOCK again
• Press CLOCK gently using a thin stick.
Signal transmitting
section
Distance of signal :
About 6 m
Beep (s) is (are) heard
from the indoor unit when
the signal is received.
Temperature buttons
Page 4
Off-timer button
Page 6
On-timer button
Page 6
TIME set buttons
Pages 3, 5
HR. button
MIN. button
CLOCK button
Page 3
RESET button
Page 3
Lid
Slide down to open
Remote controller
holder
• Install the remote control-
ler holder to a place where
the signal can be received
by the indoor unit.
2.
Press the and buttons
to set the time
Each time is pressed, the
set time increases by 1
hour, and each time is pressed,
the set time increases by 1
minute.