Enterasys RoamAbout RBT-4102 Installation Manual page 50

Access Point Configuration
b. Click the DHCP Client: Disable radio button. DHCP allows you to enable
or disable the option to obtain the IP settings for the access point from a
DHCP (Dynamic Host Configuration Protocol) server. The IP address,
subnet mask, default gateway, and Domain Name Server (DNS) address
are dynamically assigned to the access point by the network DHCP server.
Default: Enable
c. Enter the IP Address, Subnet Mask, Default Gateway, and Primary and
Secondary DNS.
Note: Enterasys Networks recommends that you reset the access point
after changing the DHCP client status.
• IP Address is the IP address of the access point. Valid IP addresses
consist of four decimal numbers, 0 to 255, separated by periods.
• Subnet Mask is the mask that identifies the host address bits used for
routing to specific subnets.
3-10