Base Board; Eptz1000Control Board - EverFocus Speed Dome EPTZ1000 User Manual

1.3.2. Base Board

The base board that is on the bottom of the housing connects to power cable, video cable,
control cable, alarm cable, fan and heater (fan and heater are for EPTZ1000 only). In
order to connect to cables, the board needs to be taken off, and put back after finishing
connecting to all cables. The connectors of cable names are marked on the board in white
text. The details of the alarm connector (JP5) are shown on the APPENDIX A.
For EPTZ1000, JP1, JP3 and JP6 that are two-pin connectors on the base board need to
be taken off during installation. JP1 and JP3 are connectors for heater, and they can be
switched. JP6 is a fan controller connector that turns on/off of the fan. The 3 cables are too
short to be connected to a wrong connector when putting them back.
RELAY
JP5
Video +
Video -
RS485 +
RS485 -
AC24
AC24
JP3 JP1
EPTZ1000 Baseboard

1.3.3. EPTZ1000Control Board

The PCB board with two dipswitches is the control board of speed dome. The two
switches are used to set address, protocol, Baud Rate, video format and terminator
resistance.
JP4
JP6
1-8