Filter - Eureka 5550 Series Owner's Manual

6. Place new belt around motor
shaft.
7. Place belt around brush roll pulley.
8. Pull right side of brush roll to stretch belt. Secure
right end cap into base.
8
Left side view
9. Align left end cap with square in base. Push end
cap into place; see left side view.
10. Rotate brush roll to seat belt.
11. Replace the hood. Make sure hood front is behind
furniture guard.
12. Tighten screws.
Use replacement belt, Style U.
12
To Change Dust Cup Pleated Filter:
NOTE: Turn off the switch and unplug the electrical
5
Dust Cup
Latch
6
7
Dust Cup
Release dust cup by rotating dust cup latch to the left
pointing to the unlock symbol ( ). Pivot dust cup out
and away from cleaner and remove.
9
Remove cyclonic dust cup by pulling latch (1) forward,
pivoting cyclonic dust cup out and lifting up. To replace
cyclonic dust cup, put bottom of cyclonic dust cup in
place by aligning tabs in slots and pivot top assembly
back into place. Push down on latch (1), making certain
that latch securely snaps and overlaps tabs at top of
dust cup.
To maintain good performance, check and clean the
Pleated Filter each time the dust cup is emptied and
clean if needed. The filter can be cleaned by washing
with mild detergent and warm water. Be sure pleated
filter is completely dry before reinstalling.
cord before changing the Pleated Filter.
Never operate the vacuum cleaner without
the dust cup or the pleated filter assembly.
1
2