Identify Parts ......5 Assembly ......6 How to Use ......7 Trouble Shooting ....8 Customer Order Form ..9 Warranty ......11 For location of nearest Eureka Warranty Station or Service Information call 1-800-282-2886*. *En Mexico llame al 5670-6169 www.eureka.com...
IMPORTANT SAFEGUARDS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. WARNING To reduce the risk of fire, electric shock or injury: • Do not use outdoors or on wet surfaces. •...
Page 3
CONSEILS DE SÉCURITÉ Lors de l’utilisation d’un appareil électrique, quelques précautions élémentaires doivent être observées, incluant les suivantes: LISEZ TOUTES LES INSTRUCTIONS AVANT D’UTILISER VOTRE ASPIRATEUR. AVERTISSEMENT Pour réduire le risque de feu, de choc électrique, ou de blessure: • N’utiliser à...
México: 5670-6169 Canada: 1-800-282-2886 If you prefer, you can write to The Eureka Company, Service Division, 807 North Main Street, Bloomington, Illinois 61701, USA. In Canada write to The Eureka Company, 866 Langs Drive, Cambridge, Ontario N3H 2N7. Refer to The Eureka Limited Warranty for complete service information.
Assembly CAUTION: Always unplug from electrical outlet before opening the dust cup. NOTE: Dust cup filter must be used when operating the hand vac. Filter Dust Cup 1. To open the dust cup, push release button and pull dust cup away from cleaner. Verify that the dust cup filter is inside, then attach the dust cup to the hand vac.
How To Operate Your Hand Vac CAUTION: The hand vac is a very powerful unit. Make sure that you hold it firmly, otherwise it can slip out of your hand and cause injury. 1. Hold the hand vac firmly with your hand on handle. 2.
Trouble Shooting Guide PROBLEM POSSIBLE REASON POSSIBLE SOLUTION Hand vac will not 1. Power cord not firmly 1. Plug unit in firmly. operate. plugged into outlet. 2. Check fuse or breaker. 2. No power in wall outlet. Replace fuse/reset breaker. Hand vac will not 1.
Need help?
Do you have a question about the 50 and is the answer not in the manual?
Questions and answers