Downloading The Latest Firmware - Enterasys ANG-1100 User Manual

Chapter 3
Configuring the ANG-1100 with Aurorean Web Config

Downloading the Latest Firmware

After logging in, download the latest firmware image to the
ANG-1100's flash memory (provided the MAC address is set for cable service
users - refer to page 36) by accessing the FTP server where it is stored. As new
firmware becomes available, you can update it again. Begin updating your
firmware by performing the following steps:
Help
VPN
VPN Status
VPN Setup
Connectivity Setup
Internet Setup
LAN Setup
Firewall Setup
Aurorean Network Gateway-1100 User's Guide
1 Click the Firmware Upgrade menu option.
The Firmware Upgrade window appears as shown in Figure 16.
Aurorean Network Gateway
Firmware Update
FTP server:
Firmware image
filepath:
Username:
Password:
Confirm:
Figure 16 Firmware Update Window
2 In the FTP server field, enter the name of the FTP server where the
new ANG image is stored: ang.enterasys.com
3 Type the full path of the location of the Firmware image:
/ANG1100/ANG1100.bin
4 Enter the Username anonymous
5 Enter netadmin in the Password and Confirm fields and click Apply.
The Firmware Update window appears as shown in Figure 17.
6 Click Apply.
Depending on your network connection, the image (nearly 2 MB)
downloads for 20-30 seconds and loads in flash memory for 2-3
minutes more. Note that the Power and VPN LEDs blink very quickly
together during this interval and then turn off. The WAN LED blinks
as well. Meanwhile, the ANG Web Config screen appears blank.
ang.enterasys.com
ANG1100/ANG1100.bin
anonymous
Apply
23