Table of Contents
Advertisement
T
roubleshooting
Reduce Spray or No Spray
Possible causes
1.
Make sure power is on
2.
Solution tank may be empty
3.
Tank may not be seated properly
4.
Hose solution line may be disconnected
5.
Wet clean is not turned on
Machine is not suctioning
Possible causes
1.
Collection tank may not be placed properly
2.
Collection tank may not be assembled properly
3.
Wand tool connections are not tight
4.
Collection tank is full
5.
Float has tripped
6.
Pre-motor filter is dirty
Built-in heater light does not illuminate
Possible causes
1.
The heater button has not been depressed
2.
The ON/OFF button has not been depressed
Other maintenance or service not included in the manual should
be performed by an authorized service representative.
Thank you for selecting a BISSELL product.
Please do not return this product to the store.
For any questions or concerns, BISSELL is happy to be of
service. Contact us directly at 1-800-237-7691.
16
w w w . b i s s e l l . c o m
WARNING:
to reduce the risk of fire,
electric shock or injury, unplug
from the outlet before servicing.
Remedies
1. Press power button if needed
2. Fill tank according to directions
3. Turn ON/OFF, heater and wet clean
button off. Remove and reseat tank
4. Check connection at front of
machine
5. Depress wet clean button to turn on
Remedies
1. Open Quick Release™ Hose Door, lift out tank
and re-seat. Re-latch Quick Release™ Hose Door
2. Check to make sure the top lid is properly seated
3. Check all connections (At grip, wand and tool)
Push tight if necessary
4. Empty collection tank by following instruction
on page 9
5. Check to see if tank needs to be emptied. Make
sure float is down towards bottom of tank
6. Remove top lid. Remove and clean pre-motor filter
by following instructions on page 15 Filter must be
completely dry before using again
Remedies
1. Depress the heater button
2. Depress the ON/OFF button
8 0 0 . 2 3 7 . 7 6 9 1
Hide quick links:
Advertisement
Table of Contents
