Craftsman 917.270742 Owner's Manual page 27

TO REPLACE HEADLIGHT BULB
• Raise hood.
,, Pull bulb holder out of the hole in the
backside of the grill.
o Replace bulb in holder and push bulb
holder securely back into the hole in
the backside of the grill.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or
prevent it from starting.
• Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with I5 amp automotive-type
plug-in fuse The fuse holder is located
behind the dash.
TO REMOVE HOOD AND GRILL
ASSEMBLY
o Raise hood_
• Unsnap headlight wire connector.
o Stand in front of tractor_ Grasp hood at
sides, tilt toward engine and lift off of
tractor°
,, To replace, reverse above procedure°
ENGINE
Maintenance, repair, or replacement of
the emission control devices and
systems, which are being done at the
customers expense, may be performed
by any non-road engine repair establish-
ment or individual. Warranty repairs must
be performed by an authorized engine
manufacturer's service outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at
the factory and adjustment should not be
necessary. Check adjustment as
described below before loosening cable°
If adjustment is necessary, proceed as
follows:
. With engine not running, move throttle
control lever from slow to choke
position. Slowly move lever from
choke to fast position.
• Check that holes "A" in governor
control lever and hole in governor
plate line-up. If holes "A" are not
aligned, loosen clamp screw and
move throttle cable until holes are
aligned. Tighten clamp screw se-
curely.
Governor
Control Lever Governor
Control Plate
Headlight Wire
Connector
\
Holes ", Clamp Screw
Throttle
Cable
27