Advertisement
,_
WARNING:
The router shouUd never be
connected to a power suppUy when you are
assembling
parts, making adjustments, cleaning,
performing maintenance, or when the tooU is not in
use. Disconnecting
the tooU prevents accidentaU
starting that couUd cause serious injury.
iNSTALLiNG
THE ROUTER
MOTOR
iN THE
BASE
See Figures 2 and 3.
Follow these steps to install the router motor in the
base.
1.
UnpUug the router.
.WARNING:
Failure to unpUugthe tooUcouUd resuUt
m serious injury due to accidentaU starting.
2.
PUace the base on a fiat surface.
3.
Loosen the bcking arm.
4.
AHgn the notch in the depth adjustment ring with the
indicator point on the base.
NOTCH
INDICATOR
POINT
Fig. 2
5.
Place the router motor upside down.
6.
Align the spindle lock button with the groove in the
base.
7.
Depress and hold the spindle lock button on the
motor.
8.
Slide the base onto the motor housing.
9.
Turn the depth adjustment ring clockwise until the
spindle lock button slides above the locking arm.
10. Tighten the locking arm.
Fig. 3
REMOVING
THE CHIP SHIELD
A clear plastic chip shield is instafled on the front of the
router base for protection against flying dust and chips.
WARNING:
Do not use the router unless the chip
shield is properly in place. Failure to heed this
warning could result in serious injury.
Follow these steps to remove the chip shield.
1.
Squeeze the tabs on each side of the chip shield.
2.
Puff out the chip shield.
Note: To replace the chip shield, squeeze the tabs
on each side of the chip shield and push the shield
into place.
Advertisement
