Table of Contents
Advertisement
Radio Programming Errors
Programming errors are divided into three categories:
1.
Protocol Errors - These are errors produced by the low level communication routines.
2.
Radio Errors - These are errors that are returned from the radio ROM or operating software.
3.
PC Errors - These are errors that are produced by the PC Programming software.
MESSAGE
Successful
Protocol - Canceled by receiver
Protocol - Canceled by sender
Protocol - Terminate transmission
Protocol - Transmit error
Protocol - Protocol initialization error
Radio - Programmed successfully
Radio - Comport configuration failed
Radio - Flash erase failed
Radio - Flash write failed
Radio - Flash code CRC did not match
Radio - Canceled by receiver
Radio - Canceled by sender
Radio - End of transmission received
Radio - Transmit error
Radio - Invalid command
Radio - No application code
Radio - Application code error
Radio - EEPROM programming error
Radio - Baud rate has changed
PC - Cannot allocate memory
PC - Cannot open data file
PC - Cannot read data file
PC - Cannot write to file
PC - File not found
PC - File is larger than radio memory
PC - Incorrect Tracking Data RF band
split
PC - Incorrect Tracking Data version
PC - Tracking Data checksum error
PC- Time-out, radio not responding
PC - Comport configuration error
PC - Abort, message canceled
PC - Requested personality data does
not exist
CODE
0
Command was performed successfully.
5
x328 protocol received a cancel. The radio detected a cancel command.
6
x 328 protocol transmitted cancel. The radio is canceling the read command.
7
x328 protocol received an end of transmission.
8
x328 protocol could not transmit. Reliable communication cannot be established. It could be
the radio or PC hardware problems (programming cable, interface box, or radio hardware).
9
x328 protocol not initialized or failed to initialize.
10
Radio responded with a success. Radio acknowledged successful programming.
11
Radio could not configure its comport (hardware failure).
12
Radio failed to erase the flash memory. The radio flash memory part is unusable or it cannot
detect the 12 volts power. Check the programming box and cables.
13
Radio failed in writing to the flash memory. Retry the programming process (hardware
failure).
14
Flash code not programmed correctly. CRC did not match. The operating software will not
execute. Re-program the radio.
15
The radio operating software received a cancel command.
16
17
The radio software received or sent an end of transmission.
18
Radio could not transmit the required data. Check all hardware connections and try
programming again.
19
Radio did not understand the received command.
20
No application code is loaded, the radio cannot accept personality commands. Re-program the
operating software (flash code) and re-program the personality.
21
The radio application code failed to perform the command.
22
Could not program the radio EEPROM part.
23
The radio acknowledged a successful baud communication baud rate change.
50
The PC programming software could not allocate adequate memory space to perform the
function.
51
The specified file (code or personality) could not be opened (file does not exist or has access
protection).
52
The specified file (code or personality) could not be read.
53
The specified file (code or personality) could not be written.
54
The specified file (code or personality) is not found in the current directory.
55
The radio flash part size is unknown or the operating software file size is larger than the radio's
flash memory size.
57
Incorrect Tracking Data RF band split.
58
Incorrect Tracking Data version.
59
Tracking Data checksum error.
60
Radio is not connected or not turned on or the selected PC comport number is invalid.
61
Comport configuration error, cannot set comport.
62
Aborted by operator, message canceled.
63
The personality table does not exist (Tracking or Encryption table).
DESCRIPTION
LBI-39175A
23
Advertisement
Table of Contents
