Craftsman 917.259330 Owner's Manual page 16

CUSTOMER RESPO
TRACTOR
Always observe safety rules when performing any mainte- BLADE
nance.
BRAKE OPERATION
If tractor requires more than six (6) feet stopping distance
at high speed in highest gear, then brake must be adjusted.
(See "TO ADJUST BRAKE" in the Service and Adjust-
ments section of this manual).
TmRES
* Maintain proper air pressure in all tires (See "PROD-
UCT SPECIFICATIONS" on page 3 of this manual).
o Keep tires free of gasoline, oil, or insect control chemi-
cals which can harm rubber.
o Avoid stumps, stones, deep ruts, sharp objects and
other hazards that may cause tire damage.
BILITIES
MANDREL
ASSEMBLY
TRAILING EDGE
FLAT WASHER ___
LOCK
HEX BOLT
(GRADE 8)*
*A GRADE 8 HEAT TREATED BOLT CAN BE
iDENTIFIED BY SIX LINES ON THE BOLT HEAD.
FiG. 13
BLADE CARE
For best results mower blades must be kept sharp. Re-
place bent or damaged blades.
BLADE REMOVAL (See Fig. 13)
o Raise mower to highest position to allow access to
blades.
, Remove hex bolt; lock washer and flat washer securing
blade.
° Install new or resharpened blade with trailing edge up
towards deck as shown.
, Reassemble hex bolt, lock washer and flat washer in
exact order as shown.
° Tighten bolt securely (30-35 Ft. Lbs. torque).
iMPORTANT: BLADE BOLT IS GRADE 8 HEATTREATED.
NOTE: We do not recommend sharpening blade - but if you
do, be sure the blade is balanced.
TO SHARPEN BLADE (See Fig, 14)
Care should be taken to keep the blade balanced. An
unbalanced blade will cause excessive vibration and even-
tuai damage to mower and engine.
o The biade can be sharpened with a file or on a grinding
wheel. Do not attempt to sharpen while on the mower.
• To check blade balance, you wilt need a 5/8" diameter
steel bolt, pin, ora cone balancer. (When using a cone
batancer, follow the instructions supplied with bal-
ancer).
Slide blade on to an unthreaded portion of the steel bolt
or pin and hold the bolt or pin parallel with the ground.
If blade is balanced, it should remain in a horizontal
position, tf either end of the blade moves downward,
sharpen the heavy end until the blade is balanced.
NOTE: Do not use a nail for balancing blade. The lobes of
the center hole may appear to be centered, but are not.
CENTER HOLE
BLADE
5/8" BOLT j' ,
OR PIN
FiG. 14
16