Table of Contents
Advertisement
Available languages
Available languages
AP1 & RP SERIES
Page
4
DAMPER /
DUCT
CONNECTOR
VERTICALDUCT
KNOCKOUT
/
i11
i/I
HORIZONTAL
DUCT
• "
KNOCKOUT
CONNECT
THE WIRING
HOUSE
POWER
CABLE
GREEN
GROUND
SCREW
[_
Connect
House
Power Cable to
hood wiring
range
- BLACK to BLACK, WHITE to WHITE, and GREEN or
BARE WIRE to GREEN Ground Screw.
3
Remove Vertical
Duct Knockout
or Horizontal
Duct
Knockout
and attach Damper / Duct Connector
with
two (2) screws (supplied).
INSTALL
THE HOOD
_
ARNING
To reduce the risk of electrical shock, switch power off
at service panel. Lock or tag service panel to prevent
power from being switched on accidentally.
COMPLETE
INSTALLATION
Re-install the wiring cover, bottom cover, and filters that
were removed in Step 3.
m
MOUNTING
SCREWS (4)
J
<t>
I
©
HOUSE
POWER
CABLE
o
!
,,
//.,d
DUCTWORK
m
m
Run House
Power Cable between
service panel and
hood location. Attach power cable to hood using appropri-
ate connector.
Hold the hood in position under the cabinet. Make sure
the damper / duct connector enters the Ductwork
and
that the damper opens and closes freely.
Tighten the four (4) Mountin,,q Screws
completely to se-
cure the hood to the cabinet.
INSTALL
LIGHT BULBS
t
(2) ROTATE
CLOCKWISE
[_
Install Halogen_ Bulbs.
Use 120 V, 50 W, shielded halo-
gen bulbs - MR16 or PAR16 with GUI0 base. Purchase
bulbs separately.
Advertisement
Table of Contents
