Attach Handleand Accessory Tray; Unpack Thepressure Washer; Carton Contents - Craftsman 580.752591 Operator's Manual

Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problemswith the assembly of your
pressurewasher, please call the pressurewasher helpline
at 1=800-222-3136.
Attach Handleand Accessory Tray
1. Place handle (A) onto handle supports (B) connectedto
main unit. Make sure holes (C) in handle align with holes
(C) on handle supports.
UNPACK THEPRESSURE WASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
* Main Unit
* Handle
* Accessory Tray
* High Pressure Hose
* Spray Gun
* Nozzle Extensionwith Quick Connect Fitting
* Quick Connect Selector Nozzle
* DetergentSiphoning Tube/Filter
* Bottle Bracket Wireform (2)
* PerfectMix
TM
Siphoning Unit/Tube
* Oil Bottle
* Parts Bag (which includes the following):
* Operator's Manual
* Owner's Registration Card
* HandleFasteningHardwareKit (which includes):
* Carriage Bolt (2)
* Plastic Knob (2)
* Tree Clips (4)
Become familiar with each piece before assembling the
pressure washer, identify all contents with the illustration on
page 6. if any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
NOTICE It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Place bottle brackets (D) facing inside over holes in
handle. Secure bottle brackets and handle with carriage
bolts (E) and plastic knobs (F). Tighten by hand.
.
Placeaccessory tray (G) over holes (H) on handle
(viewing from front of unit). Push the tree clips (J) into
the holes until they sit fiat against the accessory tray.
/
/
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle and accessory tray.
3. Connect detergent siphon tube to pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Attach nozzle extension to spray gun.
9. Attach quick connect selector nozzleto nozzle extension.
.
insert supplied accessories in spaces provided in
accessory tray. See How to Use Accessory Tray.