Dishwasherfeatures & Options - Bosch SHE43P02UC/56 Use And Care Manual

Table of Contents

Advertisement

Available languages

Available languages

Dishwasher
Features & Options
Wash Cycles
*The cycles listed below vary by models.
Power Scrub Plus
Cleans items having baked-on or hard dried food soils.
These items may require soaking or hand scouring.
Auto Plus
Designed to be used with heavily soiled dishes as well as
pots and pans
Auto Wash
The sensors in the dishwasher
automatically
adjust the
cycle
length,
temperature
and water
changes
based
on the soil load This cycle contains
additional
sensor
decisions when compared to other cycles
Auto Delicate
Designed to be used with your fragile china and glassware,
allowing you to get it perfectly clean without
the hassle of
hand washing or worry of damage in the dishwasher
Regular Wash
Thoroughly
cleans large loads having
loosely attached
normal soiling
Quick Wash
Cleans lightly soiled dishes and reduces overall wash time
Use this cycle to clean glasses and dessert dishes that may
need to be reused
at the same event
Rinse & Hold
Allows you to rinse the food soil off of a partial load and
hold them in the dishwasher until there is a full load
Wash Cycle Options
*
*The options listed below vary by models
Options can be used along with wash cycle to customize
load for personalized
results:
1 Select wash cycle
2 Select option
3 Start dishwasher
Half Load
In the Power Scrub, Regular, and Auto Wash cycles you
can reduce the energy
and water consumption
when
washing small, lightly soiled loads that fill approximately
half the dishwasher's capacity
To activate, select the Half Load button in addition
to any
of the three cycles listed above
Extra Dry Heat
With this option you can raise the temperature
of the rinse
water and increase the drying time for improved drying
NOTE: The unit must be powered OFF before activating
@@@
o _
Cancel Reset m
®
To activate:
Press and hold the left "Cancel Reset" button,
then
press and hold the ON/OFF button
For units with a display when the LED display window
indicates a "0" or "1 "release both buttons
To activate extra dry heat, press the left"Cancel
Reset"
button until the display indicates'U"
To disable extra dry heat, press the left "Cancel Reset"
button until the display indicates"0"
Press the ON/OFF button to save the setting
Delay Start
This option
allows you to delay the start time of your
dishwasher
To activate:
Turn the dishwasher on
Select the desired wash cycle
Press and
hold
the
Delay
Start button
Release
when the desired delay time is shown in the display
window
16

Advertisement

Table of Contents
loading

Table of Contents