Gigabyte GS-R12T4S Service Manual page 8

facility designatedby the supplier. Any repairs or alterations made by the user to this equipment, or equip-
ment malfunctions,may give the telecommunications company cause to request the user to disconnect the
equipment.Users should ensure for their own protection that the electrical ground connections of the power
utility,telephone lines and internal metallic water pipe system, if resent are connected together. This precau-
tionmay be particularly important in rural areas.Caution: Users should not attempt to make such connections
themselves, but should contact theappropriate electric inspection authority, or electrician, as appropriate.
NOTICE: The Load Number (LN) assigned to each terminal device denotes the percentage of the totalload
to be connected to a telephone loop which is used by the device, to prevent overloading. Thetermination on a
loop may consist of any combination of devices subject only to the requirement that thesum of the Load Num-
bers of all the devices does not exceed 100./ for European users only /
Class A equipment
This device has been tested and found to comply with the limits for a class A digital device pursuantPart 15 of
the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference when
the equipment is operated in a commercial environment. This equipmentgenerate, uses, and can radiate
radio frequency energy, and if not installed and used in accordancewith the instructions, may cause harmful
interference to radio communication. Operation of thisequipment in a residential area is likely to cause harm-
ful interference, in which case the user will berequired to correct the interference at personal expence.
However, there is no guarantee that interference will not occur in a particular installation. If thisdevice does
cause harmful interference to radio or television reception, which can be determined bytuning the device off
and on, the user is encouraged to try to correct the interference by on or more ofthe following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the device and receiver
• Connect the device into an outlet on a circuit different from that to which the receiver isconnected Consult
the dealer or an experienced radio/television technician for help.
- 8 -