Table of Contents
Advertisement
2.4
Hard disk drives
The system supports two hot-swap Serial ATA hard disk drives. The hard
disk drive installed on the left tray connects to the motherboard SATA1
(Port0) port, while the right tray hard disk drive connects to the
motherboard SATA3 (Port2) port via the SATA backplane.
To install a hot-swap SATA HDD:
1.
Release a drive tray by pushing
the spring lock to the right,
then pulling the tray lever
outward. The drive tray ejects
slightly after you pull out the
lever.
2.
Firmly hold the tray lever and
pull the drive tray out of the
bay.
3.
Take note of the drive tray
holes. Each side has three holes
to fit different types of hard
disk drives. Use two screws on
each side to secure the hard
disk drive.
4.
Place a SATA hard disk drive on
the tray, then secure it with
four screws.
2 - 1 0
2 - 1 0
2 - 1 0
2 - 1 0
2 - 1 0
C h a p t e r 2 : H a r d w a r e s e t u p
C h a p t e r 2 : H a r d w a r e s e t u p
C h a p t e r 2 : H a r d w a r e s e t u p
C h a p t e r 2 : H a r d w a r e s e t u p
C h a p t e r 2 : H a r d w a r e s e t u p
Advertisement
Table of Contents
