Setup - Altronics Air Quality Computer User Manual

By pressing "2" from the MAIN menu the unit enters SET UP. Set up
allows for configuring any one of the 10 data bases. Each data Base hold
40 runs.
The first menu appears...
Select Data Base
Yes = 1 No = 2
After selecting a data base you will be asked if you want to clear all the
runs out of it:
CLEAR RUNS?
Yes = CLEAR No = ANY KEY
You will now be asked if you want to rename it. Note: You can use the
default name if you wish "Data Base #1".
To enter a new name use the "SCROLL" key to scroll the letter up or the
CLEAR key to scroll down . When the letter is correct select Yes by
pressing "1" and you will go on to the next letter. When all the letters
have been selected press the "ENTER" key to save the name.
Yes = 1 No = 2
After selecting a data base you can exit out of SETUP if you have
already previously configured it and do not wish to make any changes.
After selecting a data base the following is displayed:
ET MODE
TS MODE
Press 1 OR 2
By pressing "1" sets the unit to the ET MODE. This means all runs
added to the data base will be stored in the ET section and the
PREDICTION will be an ET computed from the stored runs and the
present ALTITUDE (DA or OA).
SET UP
Continue?
= 1
= 2
7