Advertisement
Available languages
Available languages
Washer
or Dryer is in its Packaging
Excessive Weight Hazard
Use two or more peop}e to move washer or dryer.
Failure to do so can result in back or other injury.
2.
Lay washer or dryer on its back.
NOTE: When laying the washer on its back, hold the bottom
cap down on the floor. Do not remove the plastic film, corner
posts or top cap. These protect the floor and washer back.
When laying the dryer on its back, the floor and dryer back
are protected by pieces of the carton.
1=
Position the packaged washer or dryer close to its final
position. Cut the packaging as follows:
Washer: Cut plastic
film along dotted
cut line around the
base. Do not
remove the
packaging.
Dryer: Cut carton
A
around top and
down corners
along dotted cut
lines. Lay all four
A. Cartonsides
carton sides on
floor. Discard carton top and corner posts.
IMPORTANT: Leave carton bottom underneath dryer.
INSTALLATION
iNSTRUCTIONS
Follow these instructions to install the pedestal on a washer or dryer.
Excessive Weight Hazard
Use two or more people to move and install pedestal.
Failure to do so can result in back or other injury.
1=
Open the pedestal
drawer as far as possible
and remove the
contents. This package
contains 4, #12 x %" hex
head sheet metal screws
used in step 5 and
divider pack.
2.
3=
Verify the 4 spacer pads
are installed on the top of
the pedestal.
...............
A
A. Spacer pads
Using 1/4" nut driver, remove the hex-head screws from both
drawer slides and save screws. Remove
the drawer from the slides and set _I'__
aside. Push the slides back
_
/,_
into the pedeltal.
A. Drawerslide
_U
_
B
B. Hex-headscrew
Advertisement
