Image Adj - Sanyo PLC-WL2503A Owner's Manual

Image adj.

This function is to adjust the projected picture image and save the image mode. To store
the adjusted value, click Store button, and to load the adjusted value, click Load button.
Item Description
Contrast .............................. Adjusts picture con-
trast (0~ 63)
Brightness ......................... Adjusts picture bright-
ness (0~ 63)
Color ...................................... Adjusts picture color
saturation (0~ 63)
Tint ......................................... Adjusts picture hue
(0~ 63)
Color temp. ....................... Sets a color tem-
perature mode. {X Low,
Low, Mid, High, Adj.
Blackboard(Green),
Colorboard}
White balance
Red, Green, Blue ..... Adjusts each white
balance respectively.
(0~ 63)
* When changing the value of the
white balance, the color temp.
indicates "User".
Sharpness ................................ Adjusts picture sharpness. (0~ 15)
Gamma .......................................... Adjusts brightness of darker part of the picture. (0~ 15)
Noise reduction ................ Switches noise reduction mode (OFF, L1, L2)
Progressive . ........................... Switches progressive mode (OFF, L1, L2, Film)
Reset............................................Resets the Image adjustment to previous levels.
Store ............................................ Stores the Image adjustment values. Select an item [Image1 - Image4] from
Load ............................................. Loads the Image mode. Select an image mode from the pull-down menu
Input source
Image mode Video Computer
Dynamic
4
Standard
4
Cinema
4
Real *
Blackboard(Green)
4
Colorboard
4
Image1 - 4
4
the pull-down menu and click Store button.
and click Load button. There may not be available mode depending on the
input mode as shown in the table left.
4
4
*
4
4
✐ The mark "
4
selected input source. The error message appears when
4 selecting the disabled image mode indicated with "*".
" means that the available image mode in the
4
Control