During Washing; Re-Selecting A Program; Add A Garment / Interrupting The Program; Canceling The Active Program - Bosch Vision 300 Operating, Care And Installation Instructions Manual

During Washing
The washer drum system may
experience a slight shudder or
shake as the drum accelerates
to higher spin speeds due to
normal laundry imbalance.
Re-selecting a cycle
CI Turn the cycle selector to Off.
CI Turn the cycle selector to a newly
selected cycle.
The Start/Pause indicator light
flashes.
CI If required, change the settings.
CI Pressthe Start/Pause button.
The cycle starts.
Add a garment /
Interrupting the cycle
You can put laundry in the drum after
washing begins, take laundry out of the
drum early or interrupt the cycle at any
time.
D It is not recommended to add
laundry after the washing phase is
complete.
D You can add or reduce laundry as
long as the Start/Pause indicator
light flashes and it is safe to do so.
CI Open the door.
CI Add/remove the laundry.
CI Close the door.
CI Pressthe Start/Pause button.
The cycle continues.
The indicator light is lit.
D When the Start/Pause indicator
light is illuminated, the cycle can
be interrupted, however in some
cases the door will not be
unlocked for safety reasons (high
water level, water temperature or
drum speed).
D If the speed is too high, the
Start/Pause indicator light is
illuminated. Laundry can be added
in "Pause" mode when the drum is
at a standstill.
Canceling the active cycle
If you would like to terminate a cycle
and remove the laundry:
CI Pressthe Start/Pause button
CI
If Child Lock is active, it is
necessary to press and hold down
the Start/Pause button for five
seconds
CI
If the load is too wet, turn the cycle
selector to Drain/Spin and run the
cycle using a spin speed
appropriate for the laundry type
(see pg. 22 for suggested spin
speeds).
If a cycle is interrupted at a high
temperature, the door will remain
locked until the temperature in the
drum has cooled down.
If the cycle is terminated by
switching the appliance to "Off ",
the door will may remain locked
until the appliance is switched
back on. Turn the cycle selector
to any other cycle. The door will
unlock after approximately 5
seconds.
After Washing
The Start/Pause indicator light turns
off.
Display shows: "0:00" and Finished
LED is lit.
CI Open the door.
CI Turn the cycle selector to Off.
I
CI Close the faucets.
CI Remove the laundry.
To avoid the risk of rust, check for
foreign objects (e.g. coins, paper
clips) between the drum and rubber
door seal.
DAfter washing, leave the washer
loading door open for 24 hours to
allow the inside of the washing
machine to dry.
26