Download Print this page

Important Safety Instructions; Special Instructions - Black & Decker D2000 Series Use And Care Book Manual

Hide thumbs Also See for D2000 Series:


When using your iron, basic safety precautions should always be followed, including the following:
Q Use iron only for its intended use
LI To protect against a risk of electric shack, do not immerse the iron in water or other liquid,,
C] The iron should always be turned off (refer to "How to Use" section) before plugging into or unplugging from
an outfeL Never yank cord to disconnect from outlet; instead grasp plug and pul! to disconnect
E3 Do not allow cord to touch hot surfaces Let iron cool completely before putting away Loop cord loosely
around cord wrap when storing
Q Always disconnect iron from electrical outlet when filling with or emptying of water and when not in use
Q Do not operate iron with a damaged card or if the iron has been dropped or damaged. To avoid the risk of
electric shock, do not disassemble the iron, take it to a qualified serviceman for examination and repair,
Incorrect reassembJycan cause a risk of electric shock when the iron is used
CI Close supervision is necessary for any appliance being used by or near children,, Do not leave iron
unattended while connected or on an ironing board_
CI Burns can occur from touching hot metal parts, hot water, or steam° Use caution when you turn a steam
iron upside down or use the surge of steam -- there may be hot water in the water tank,_Avoid rapid
movement of iron to minimize hot water spillage_
CI To avoid a circuit overload, do not operate another high-wattage appliance an the same circuit
CI If an extension cord is absolutely necessary, a 15-amperes and 120-volt, or 7-ampere and 220-volt cord
should be used_ Cords rated for less amperage may overheat,, Care should be taken to arrange the cord
so that it cannot be pulled or tripped over°
Soft-Touch Parts
Note: The soft-touch parts of this unit are free of natural rubber and latex, They are safe for individuals allergic or sen-
sitive to these materials.,
POLARIZED PLUG (120V Models Only)
This appliance has a poJarized plug (one blade is wider than the other) rTo reduce the risk of electric shock, this plug will [it
into a polarized outlet only one way If the plug does not fit fully in the outlet_ reverse the plug If it still does not fit, contact
a qualified electrician Do not attempt to modify the plug in any way,
Warning : This appliance is equipped with a tamper-resistant screw to prevent removal of the outer cover, To reduce the risk
of fire or electric shock, do not attempt to remove the outer cover,There are no user-serviceable parts inside Repair should
be done onl.__v by"authorized service personnel
NOTE: If the power supply cord is damaged, it must be replaced by the manufacturer
or its service agent or a
similarly qualified person in order to avoid a hazard.