The Controls - Ariston A45V Use And Care & Installation Instructions Manual

The Controls
Drying Light
Heating Light
Low Heat Light
Air Fluff phase
Crease Care
phase
This light will come on whenever a program is active (running).
If this light flashes it means that an automatic programme has
exceeded 180 minutes. For safety reasons this being the maximum
drying time available.
Should this occur, the causes may be:
• The load is too big, or bulky.
• The filter is blocked.
• A cotton load was spun at LOW speed.
• There may be a fault.
Turn the dryer Off, check through the first three causes, and then try
again.
This light comes on during the drying part of the program, except for
the short periods during the drum reverse action.
This light comes on to indicate that the dryer is running on the low
heat setting.
About 10 minutes before the program is completed, the heating
elements will be turned off and the program enters the final 'Air Fluff'
phase. During this phase, the fabric is cooled. You should always
allow the dryer to complete this phase.
By opening the door, you can check the dryness of the load as often
as you wish and if you want, remove some items before they are fully
dry. (This is particularly useful for a mixed load where you want to iron
some items, but others to be fully dried.)
You will need to press the START button after closing the door to
re-start the program. See previous page.
At the end of the drying program it may not be convenient to take out
the clothes immediately. Do not worry, the dryer will protect your
clothes from creasing by gently turning them over occasionally with a
few revolutions of the drum. At the same time a warning buzzer will
sound intermittently to remind you that the clothes are ready to take
out.