Akai PDP4290 Owner's Instructions Manual page 16

Remove four large screws from the rear side of the display,
[
iiiiiiiiiiiii!iii%iii?ii!%i_i_
Insert the bolts and insulation sJnto the four screwholes as shown in the follow-
ing figure:
0 _olt
0 Insulation holder 0
-0
II
Put the insulation rubber point protruding from the rear top or the display in
the groove on the top of the wall attachment panel. Lift up the display a little
bit so that the insulation rubber point at the bottom of the rear side of the
display is put in the groove at the bottom or the wall attachment panel.
(Do not lift the display with any pressure. The insulation rubber at the top may
be taken off. )
0
16